Step 8 – You should be prompted to login as follows: Step 7 – Once the “Debug” status shows “Enabled” then open PuTTY and configure as follows: You will also need to remember the IP Address Step 6 – Click the link against the MAC address you want to manually upgrade under “Debug”Ĭlick “Enabled” then enter the password – In this example we have used “admin” as the password. WLAN > Administration > AP Management > Advanced Settings Step 5 – Change AP status to “Debug Mode” – You will need to identify the MAC address of the problematic AP You should be prompted with the login page – Login with your details (Our example was: admin and password: admin) In our example we have used the IP address of 192.168.1.161 Step 4 – Enter the web GUI interface of the DWS-3160-24PC using its IP address in a web browser. Step 3 – Transfer the firmware downloaded and place into the “Current Directory” Server interfaces: 192.168.1.136 (This is the IP address to where the tftp server resides) Step 2 – Install and configure tftp server as follows:Ĭurrent Directory: C:\Program Files\Tftpd32 Step 1 – Download the firmware for the AP – In our example we have used the DLW-8610AP NOTE: This is a procedure in case upgrading via switch is unsuccesfulġ) FW: DWL-8610_FW_v_4.3.0.2_B053.tar (Please always check our website for new release)ģ) Tftp Server (Install the “Standard Editiion” – depending on plataform 32 or 64 bit)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |